Filter
Top Products
www.desatech.com
111916-01F 11
INSTALLATION
Continued
3. Undo latches located on top and bottom of
firebox (see Figure 17). Carefully swing door
to the left. The glass door is securely mounted
to the firebox with 5 screws.
Figure 16 - Removing Louvers
Figure 17 - Spring Latches
Glass
Locating
Holes
Spring
Latch
Bottom Louver
Open
Close
INSTALLING LOG SET
Each log is marked with a number in the following
diagram. These numbers will help in identify
-
ing the logs when installed. It is very important
to install these logs exactly as instructed. Do
not modify logs. Only use logs supplied with
fireplace.
Models CD32M and CD36M-A Series
1. Place log #1 (back log) on top of grate as
shown in Figure 18 for the CD36M-A Series.
Log #1 will go in front of the metal partition
on grate (see Figure 18). Make sure notches
in bottom of log fit over grate.
2. Place log #2 (large front log) over pins on grate
(see Figure 19).
3. Place log #3 (c-shaped crossover log) onto rear
and front logs as shown in Figure 20. Make
sure it is seated properly on the smooth surface
on front log and on the pin on back log.
4. Place log #4 (small round log) on pin on right
side of front log (see Figure 21).
Figure 18 - Installing Log #1
(CD36M-A Series Shown)
Figure 19 - Installing Log #2
(CD36M-A Series Shown)
1
2
CD32M
Log #1
Placement
3
Figure 20 - Installing Log #3
(CD36M-A Series Shown)
4
Figure 21 - Installing Log #4
(CD36M-A Series Shown)