Filter
Top Products
111161-01A
14
For more information, visit www.desatech.com
For more information, visit www.desatech.com
INSTALLATION
Installing Wireless Remote Control Accessory
Installing Logs (Models CCL3018PR, CCL3018NR, CCL3924PR, CCL3924NR,
CCL3930PR, AND CCL3930NR)
INSTALLATION
Continued
INSTALLING WIRELESS REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included) are required to operate
this heater with the wireless hand-held remote control set. One
battery must be installed in the receiver and one in the hand-held
remote control unit.
Note:
Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of heater.
2. Locate the battery clip mounted on the back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Figure 21 - Installing Receiver on the Back of the Base
Battery Clip
9-Volt
Battery
Receiver
Terminal
Wires
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery. Place battery into the bat-
tery housing.
3. Replace battery cover onto remote control unit.
Battery Cover
9-Volt
Battery
Terminal
Wires
Figure 22 - Installing Battery in Hand-Held Remote Control Unit
Remote
Control
Unit
Battery
Housing
Figure 23 - Installing Battery in Hand-Held Remote Control Unit
(GHRCTA Series)
Remote
Control
Unit
INSTALLING LOGS (CCL3018PR/PRA,
CCL3018NR/NRA, CCL3924PR/PRA,
CCL3924NR/NRA, CCL3930PR/PRA, AND
CCL3930NR/NRA)
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify
the log when installing. It is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs supplied with heater.
1. Place the front log (#1) on the grate fingers. Make sure the
front log rests firmly between the grate fingers and the grate
base (see Figure 24).
2. Place the base of the middle log (#2) in the U-shaped slots of the
grate base. The cutout on the right of the middle log should fit
over the burner (see Figure 25). Make sure the front of the middle
log is resting on the tabs of the grate base.
A
U
T
O
O
F
F
O
N
Figure 24 - Installing Front Log (#1) (CCL3930PR/NR Shown)
Front Log (#1)
Grate
Fingers
Grate Base
A
U
T
O
O
F
F
O
N
Figure 25 - Installing Middle Log (#2) (CCL3930PR/NR Shown)
Middle Log (#2)
Tab
Burner
U-Shaped Slot