Filter
Top Products
14
104025
INSTALLING
Continued
8. Set one-piece log on heater base as shown in Figure 15. Make sure middle
section at bottom of log is seated into "U" shaped cutout in center of heater
base. Log will fit securely on base. IMPORTANT: Make sure log does not
cover any burner ports and does not touch the stove cavity (see Figure 16).
Burner Porting Areas
(double slotted
rectangular openings
Figure 16 - Top View of One-Piece Log Set on Gas Log Heater
Safety Pilot
Location
One-Piece
Log Set
9. Fasten back panel to stove with six (6) M6 x 1.20mm bolts and washers. Make
sure product identification label is located on the outside lower left-hand
corner.
10. Place freestanding stove in desired position in room. Be sure to maintain
clearances to combustibles as outlined on page 8.
Figure 15 - Installing One-Piece Stove Log Set
One-Piece
Log Set
Heater Base
"U" Shaped
Cutout in Chassis
Burner
Middle Section at
Bottom of Log Set