4
appliance, particularly in the vicinity of young children.
- A safety device will turn the radiator o. To reset, contact
the technical assistance service.
Use in compliance with intended use
Use this heater only as described in this manual. All other use is
considered improper.
This appliance is not suitable for commercial use.
The manufacturer is not liable for damage deriving from
improper use of the appliance. This is a household appliance
only. It is not intended to be used in:
• staff kitchen areas in shops, offices and other working
environments;
• farm houses;
• by clients in hotels, motels and other residential type
environments;
• bed and breakfast type environments.
Use in this manner will invalidate the manufacturers warranty.
Introduction
Thank you for choosing the TRD Oil Filled Radiator. We hope you
enjoy using your new appliance.
Take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
DESCRIPTION
(see figure on pag. 2).
The terminology below will be used repeatedly in the
following pages.
A Display
B On-standby button
C Power button
D Decrease button
E Increase button
F Timer button
G Brightness button
H Eco button
I Cord holder
L Easy wheels
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint nish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
Electrical connection
- Before plugging the radiator into the mains, check that
your supply voltage is the same as that shown on the
rating plate of the appliance.
- If using more than one radiator at a time, it is important
to ensure that the house mains is adequate to cope with
the power requirements.
- It is important to ensure that the socket is adequately
earthed.
- This appliance complies with directive 2004/108/ec on
electromagnetic compatibility.
The appliance will be set in the stand-by condition.
The display will show the symbol. Keep loose clothing
or bedding, furniture and ammable material away from
the power outlet where the heater is plugged in. After an
interruption of the power supply (power failure or appliance
unplugged) the unit always reverts to o. When the unit
is switched on by pressing the on-standby button, the
operating conditions will be the same ones previously set.
First use
The rst time the appliance is used, run it at the maximum
power for at least two hours.
During this time, ventilate the room thoroughly to eliminate
the “new” smell released by the appliance. It is completely
normal for the appliance to emit “creaking” sounds the rst
time it is run.
Heating
To turn the appliance on, press the (B) button.
Press button (C) to set the required power level:
MIN ( ); MED ( ); MAX ( ).
To select the desired temperature, press button + or - (E or D).
By pushing the + or - button once, the temperature (shown
Fig. 1