INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control.
• Insert two “AAA” 1.5V batteries, making sure they are in the cor-
rect position (see the instructions inside the battery compart-
ment).
• Replace the cover.
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment.
Warning: do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium) bat-
teries. Do not dispose of batteries in fire. Batteries may explode
or leak.
If the remote control is not be used for a certain length of time,
remove the batteries.
SETTING THE TIME
After having inserted the batteries, the clock on the display flashes
until the time is set.
Proceed as follows:
• Press the or button until the correct time is reached. Hold
the button down to run rapidly through first the minutes, then the
tens of minutes and then the hours.
• Once the correct time has been reached, release the button and
press the OK button to confirm.
• To cancel the settings programmed on the remote control and
restore the original settings, press the reset button lightly with the
point of a pencil or pen.
USING THE REMOTE CONTROL
The first set of buttons on the
remote control are the same
as those on the control panel
of the appliance. You should
therefore refer to the instruc-
tions in the chapter Operating
from the control panel to turn
the appliance on, select the
operating mode (AIR CONDITIONING, DEHUMIDIFYING, FAN, HEA-
TING or SMART) and the fan speed.
The following section describes the ADDITIONAL FUNCTIONS
corre-
sponding to the controls on the bottom part of the remote control.
BOOST FUNCTION
Ideal for the summer to cool rooms rapidly.
To set this mode:
• Press the button.
The appliance operates in air conditioning mode at maximum fan
speed.
While this function is selected, it is not possible to set the tem-
perature or change fan speed.
Note:-
BOOST
function cannot be set during HEATING mode
11
Using the remote control
✔
✔