DeLonghi PAC-A130HPE Air Conditioner User Manual


 
10
Description of the remote control
DESCRIPTION OF THE REMOTE CONTROL
1 Signal transmission
2 Air conditioning symbol
3 Dehumidifying symbol
4 Fan symbol
5 HEATING symbol
6 SMART symbol
7 Selected temperature scale indicator
8 Temperature selected
9 SLEEP symbol
10 BOOST symbol
11 Fan speed indicator
12 AUTOFAN indicator
13 Clock
14 Timer 'start-up' button
15 Timer 'shut-down' symbol
16 ON/Standby button
17 MODE button (selects the modes)
18 FAN button
19 Increase (+) and decrease (-) temperature button
20 OK button
21 Timer 'shut-down' button
22 °C or °F selection button
23 SLEEP button
24 BOOST button
25 Timer 'start-up' button
26 Reset button (resets the appliance to the original settings)
USING THE REMOTE CONTROL
Point the remote control at the receiver on the applian-
ce. The remote control must be no more than 23 ft (7
metres) away from the appliance (wi thout obstacles
between the remote control and the receiver).
The remote control must be handled with extreme care. Do
not drop it or expose it to direct sunlight or sources of heat.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) this device may not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the customer service call center or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
4
6
7
8
9
11
13
15
14
16
18
19
10
12
17
26
25
24
23
22
21
20
MAX 23 ft
MAX 7 metres