Filter
Top Products
Time Override
If you wish to operate the heater without timer, press the “ON MODE” button. The yellow
timer pilot light will go off.
5) MODELS WITH ROTATING BODY
This appliance is fitted with a motorized base and a rotating body.
To distribute the air flow over a larger area, press the oversized switch (Fig. 3).
When activated, the appliance will oscillate from right to left over an angle of
approximately 30°. To terminate oscillating, simply press the oversized switch again.
IMPORTANT
You must leave the heater plugged in and switched on at the mains socket to keep the
heaters memory programmed.
If you do not require the heater to operate in accordance with the timed programmes simply
operate via the “ON MODE” button.
If the heater looses its electricity supply for more than 2 minutes, e.g. switched off at the
mains socket or in the event of a power failure, the heater’s programmes will be lost, and
the heater will not work until reset.
In the event of a blackout , the appliance will not switch on again automatically.
To switch the appliance back on, repeat the procedure described above.
MAINTENANCE AND SERVICE
Always remove the plug from the power socket and allow the heater to cool. After the heater
has cooled, clean it with a soft damp cloth, do not use detergents or abrasives. Periodically
clean the air intake and outlet grilles during the period in which the heater is in use with a
vacuum cleaner.
Should the heater not be in use over a certain length of time, store it in a dry place.
This appliance has been built to provide many years of trouble free service.
In case of malfunction, do not try to repair the heater yourself: it may result in fire hazard or
electric shock. Call the nearest Service Center (see attached list of Service Centers).
ATTENTION
A safety device switches the fan heater off if it accidentally overheats. An audible signal warns
of any problems. To reset the unit for normal operation, remove the plug from the mains socket
for a few minutes, eliminate the cause of overheating (e.g. air intake or outlet grilles obstructed)
and then plug the fan heater back in again. Contact your nearest Service Center if the fan
heater does not begin normal operation again.
7
Fig. 3
GB 10-05-2001 9:00 Pagina 7