Filter
Top Products
6
4) PROGRAMMING THE ELECTRONIC TIMER
The timer allows you to set 2 programmes in a 24 hour period to programme the timer.
1. Press the button “ AUTO” (fig. 2), this accesses the 1st programme (programme A).
The yellow timer ON lamp will light up.
2. Set the start time for your programme by pressing the “hour button” to set the hour AM
and PM and the “min” button to set the minutes.
3. To select how long you require the heater to be on, push button “ “ and push
repeatedly until your chosen operating timespan appears. The time periods you are
able to choose from are (15’, 30’, 45’, 1hr, 2hr, 4hr (max)).
4. To programme the a second time period (programme B) press the “ AUTO” button
twice and proceed as above.
(Note: The operating period must be the same as in programme A, if the operating time
is changed eg. from 45 mins to 1hr, both programmes will operate for 1 hr).
5. Now set the comfort temperature as previously described by using the thermostat dial.
The power level will automatically be set to maximum and will reduce to the lower
power levels as required.
The heater will switch on automatically every day at the preset time for the designated
time period and will automatically maintain the selected confort temperature. If you wish
to cancel a programme depress the “ AUTO” button and then the “
hour” and “min”
buttons until the display shows:
MANAUTO
O
°
F
AM
/
AUTO
°
F
O
AUTO
AM
O
AUTO
AM
operation time
starting time program A starting time program B
O
Fig. 2
TIMER ON
yellow lamp
GB 10-05-2001 9:00 Pagina 6