Filter
Top Products
7
MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the radiator to cool. Wipe radiator with a soft damp cloth,
do not use detergents and abrasives. Should the radiator not be in use over a certain length of time, wind the cable
round the holder and store it in a dry place. This appliance has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: it may result in a fire hazard or electric
shock. Call the nearest Service Center (see attached list of Service Centers) or call customer support at 1-800-322-
3848.
TROUBLESHOOTING
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference will not occur in a par-
ticular installation. lf this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not approved by the party responsible for compliance could void user’s authority to operate
the equipment.
PROBLEM
CAUSE
SOLUTION
The appliance doesn’t work
The remote control doesn’t
work
• Be sure it is plugged in and that
the electrical outlet is working.
• Check for any obstruction.
• The thermostat may be set too
low.
• Check the batteries have been cor-
rectly positioned.
• The batteries are discharged.
• Plug into the mains.
• Remove the obstruction and let
the appliance cool down. If the
appliance doesn’t work please
contact the nearest service cen-
ter.
• Set the thermostat in a higher
position.
• Position the batteries correctly.
• Replace the batteries.