Filter
Top Products
TIMER OVERRIDE
To operate the appliance without using the programs (timer), press the “ON MODE” button (Fig.2). The yellow lamp
“ “ will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does not switch on. The display
shows the blinking numbers. To switch it on, repeat the above described operations.
Remote Control
The appliance can be completely controlled with the remote control.
- Remove the cover on the rear of the remote control;
- Insert two AAA 1.5V batteries (included) making sure they are in the correct position (see the instructions
inside the battery compartment);
- Do not mix old and new batteries
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries
- Replace the cover;
- Old batteries must be removed and disposed of in accordance with current legislation as they are harmful
to the environment.
Remote Control Operation
- When you press the frost protection push button, the radiator will set the temperature to 42°F (5.6°C) and will
switch on automatically only if the room temperature falls below 42°F (5.6°C), thereby preventing freezing, at
minimum energy consumption.
The “ “ light on the control panel will flash.
- Press the increase/decrease temperature button (+/-) to adjust the temperature from 42 to 95°F (5.6 to 35°C).
- The “Off” button switches off the appliance.
Every time you press a button, the appliance will confirm the selection with a “beep” and the pilot light on the
remote control will illuminate.
WARNINGS
You must leave the heater plugged into the outlet to keep the timer memory programmed.
If the heater loses its power supply for more than 2 minutes, (e.g. switched off at the outlet or in the event of a
power failure), the heater’s programs will be lost, and the heater will not work until reset.
SAFETY DEVICE
A safety device switches the heater off in the event of overheating. To restart the heater, call the nearest ser-
vice center.
Note: when the safety device intervenes, the heater doesn’t heat but the display works.
6
+
-