Filter
Top Products
OPERATION
PASSIVE ARMING / PASSIVE LOCK MODES
If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last door
has been closed. The lights will flash twice when the last door is closed and the LED will begin flashing rapidly while
counting down. If a door is reopened the countdown will reset and, the system will wait for the door or zone to close
before starting 30 second countdown again. The unit will chirp once and flash the lights once. Doors will lock if
passive locking is selected. May qualify for insurance discounts-check with your agent or proprietor. See Jumper
Plug programming for J1 Passive Arm and J2 Passive Lock settings.
DOME LIGHT ILLUMINATION (OPTIONAL)
This feature turns on the vehicles dome light upon disarm for 30 seconds or until the key is inserted and turned on.
This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security. (Extra parts
and/or labor may be required for this feature.)
DOOR OPEN WARNING
If the system detects a faulty or open zone (Door left open), it will notify you by providing 5 warning chirps from the
siren and 5 light flashes 60 seconds after arming. If you receive this warning, check to see if a door or trunk is ajar.
If you are unable to do so, then this particular zone will NOT be protected by the alarm. All remaining functioning
zones will still be protected if the system remains armed.
AUTOLOCK/UNLOCK
Autolock / Unlock allows the alarm to control the door locks automatically with the vehicle’s Ignition. When the
ignition is turned on, 5 seconds later, the doors will lock. When the ignition is turned off, the doors will unlock.
Doorlock with Ignition ON will not occur if a door is open to prevent accidentally locking the keys in the vehicle.
2
nd
AUX. OUTPUT (REMOTE AUX. OUTPUT 2)
To activate the second auxiliary output, press and hold Button #4 (SLNT) for more than 2 seconds. If the system is
armed, you will need to press and hold Button #4 a second time to activate the feature. (The first time activates
sensor bypass only) This output can be used to control other optional add-on accessories such as Remote Engine
Start Modules, Window Roll up/down modules, etc. This output is momentary and will stay active as long as the
button on the remote is held down.
18