Filter
Top Products
Refreshment Center Operators’ Guide Programming Procedures
December 2004 67 4800006
COUPLE/UNCOUPLE TRAY MOTORS
Two motors may be electronically coupled to turn together to vend a wide product. In some
cases, you may need to connect or disconnect the wire harness from a specific motor. See
"Set Up A Tray To Vend Wide Products" on page 18.
NOTE:
An even numbered motor (0, 2, 4, etc.) may only be
coupled to an odd numbered motor (1, 3, 5, etc.)
1. Press , then press until the display shows .
2. Press the letter of the tray you want to couple, or press to couple motors on tray
A, then press to get to the desired tray.
COUPLE ADJACENT MOTORS:
a. The display shows . This display means that on the A tray, all
adjacent motors (0 and 1, 2 and 3, etc.) are coupled.
NOTE:
The +s and As represent motor positions 0 through 9.
b. On the control panel, press the EVEN motor number of the pair you wish to couple or
uncouple. In our example, to uncouple motors 0 and 1, press 0. The display will
now show .
COUPLE NON-ADJACENT MOTORS:
a. Disconnect the motor(s) between the two you want to couple. See "Connect and
Disconnect a Motor Harness" on page 24 for information on how to do this. The
display shows . This display means that on the A tray, adjacent
motors 0 and 1 are NOT coupled, 2 is coupled to 5, 6 is coupled to 7, and 8 is
coupled to 9.
NOTE:
The +s and As represent motor positions 0 through 9. If a motor is
disconnected or not present (motors 3 and 4 in this example),
its position is replaced by an empty space.
b. On the control panel, press the motor number of the even motor of the motor pair you
wish to couple or uncouple. For example, to uncouple motors 2 and 5, press 2. The
+ representing motor number 2 changes to a C. Please note that the left motor of a
coupled pair MUST be an even-numbered motor.
3. CONTINUE.