Filter
Top Products
8
Door
End
Sprocket
End
Rail Assembly
Carton
Remove
Cardboard Packing
Remove
Cardboard Packing
Rail
Support
Braces
Straight
Door Arm
Rail Assembly
Hardware Bag
Chassis Assembly
Hardware Bag
Assembly Step 1
Assemble the Rail
ASSEMBLY SECTION: PAGES 8 - 11
Door End
Sprocket
Trolley Rack
Rotate
1. Turn the opened rail carton upside down, emptying its
contents onto a level work surface.
2. Unfold the rails, taking care to avoid kinking the screw
rod joint.
3. Rotate the rail sections so that the flat side is down and
the screw side is up. Keep it clean and free of debris
while you are working.
CAUTION: During assembly, avoid pulling the rail
section housing the trolley rack away from the screw
rod. The rack is factory set about 9" from the end of the
screw rod to the center of the rack.
If the plastic liner slides part way out during assembly,
simply push it back in.
To avoid installation difficulties, do not run the garage
door opener until instructed to do so.