Filter
Top Products
Press the lighted push button to open or close the door.
Press again to reverse the door during the closing cycle or
to stop the door while it's opening.
Premium Console:
Light feature: Press the large round Light button. If the
opener light is off, it will turn on. If the opener light is on,
(even in the 4-1/2 minute automatic cycle) it will turn off.
But if you use the Light button to turn the lights on and
then activate the opener, the lights will turn off after 4-1/2
minutes.
The Light button will not control the opener lights when
the door is in motion.
Premium Console (cont.):
Lock feature: The Lock feature is designed to prevent
operation of the door from remote controls. However, the
door will open and close from the Door Control, the
Outdoor Key Switch and the Keyless Entry Accessories.
To activate: Press and hold the small round Lock button
for 2 seconds. The push button light will flash as long as
the Lock feature is on.
To turn off: Press and hold the Lock button again for
2 seconds.The push button light will stop flashing. The
Lock feature will also turn off whenever the SRT button
on the opener panel is activated.
32
Activate the opener with any of the following:
• The Remote Control: Hold push button down until the
door starts to move.
• The Door Control: Hold push bar or button down until
the door starts to move.
• The Outdoor Key Switch or Keyless Entry:
(See Accessories)
When the opener is activated with the safety reversing
sensor installed and correctly aligned:
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for entry
and exit of pets and for fresh air).
4. If the door has been stopped in a partially open position,
it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle, and
the opener lights will blink for 5 seconds, when the
invisible beam is broken. If fully open, the door will not
close when the beam is broken. The sensor has no effect
in the opening cycle.
If the sensor is not installed, or is not aligned correctly, the
door won't close from any remote control. You can close
the door with the Door Control, the Outdoor Key Switch,
or Keyless Entry, however, if you activate them until down
travel is complete. If you release them too soon, the door
will reverse.
The Opener Lights will turn on under the following
conditions: When the opener is initially plugged in; when the
power is interrupted; when the opener is activated. It will
turn off automatically after 4-1/2 minutes or provide
constant light when the Light feature on the Premium
Control Console is activated. Bulb size is 100 watts
maximum.
SECURITY✚ models: Lights will also turn on when
someone walks through the open garage door. With a
Premium Control Console, this feature may be turned off
as follows: With the opener lights off, press and hold the
light button for 10 seconds, until the light goes on and off
again. To restore this feature, start with the opener lights
on, then press and hold the light button for 10 seconds.
NOTICE
Emergency
Release
Handle
(Pull at 45° angle)
Trolley
Trolley
Release Arm
Lockout position
(Manual disconnect)
To reconnect
Weak or broken springs could allow an open door to fall
(either rapidly or unexpectedly), resulting in serious
injury, death or property damage.
If possible, use the
manual release rope and handle
only
when the door is
fully closed.
Operation of Your Opener
WARNING
To open the door manually:
The door should be fully
closed if possible. Pull down
on the emergency release
handle (so that the trolley
release arm snaps into a
vertical position) and lift the
door manually. The lockout
feature prevents the trolley
from reconnecting auto-
matically, and the door can
be raised and lowered
manually as often as
necessary.
To reengage the trolley:
Pull the emergency release
handle toward the opener at a
45° degree angle so that the
trolley release arm is
horizontal. The trolley will
reconnect on the next UP or
DOWN operation, either
manually or by pressing the
Door Control push button.
Trolley
NOTICE
Trolley
ReleaseArm
(in Manual
Disconnect
Position)
Operation of the Door Controls
(SECURITY✚ models: See additional programming features, next page.)