Filter
Top Products
Page 6
OPTIONAL KITS
For special installation applications and modifications, the following kits are available from your local dealer. To
ensure safe, efficient operation of your Direct Vent Gas Baseboard be sure to use only authorized kits.
Table 1: Special adaptation and modification kits available for use with the Direct Vent Baseboard Heaters.
MODEL # DESCRIPTION CONTENTS
VWSK5/10 Vent Weather Seal Kit 2” diameter PVC pipe, external wall seal, O-ring, 2 PVC straps,
PVC glue, instructions.
VRK5/10 Vent Riser Kit Wall mount plate, 21-1/2” stainless steel vent riser, instructions
SVCK5/10 Side Valve Concealer Kit 4” cabinet extension, wall plate, screws, instructions
BVCK5/10 Bottom Valve Concealer Kit 4” cover, wall plate, screws, instructions
INSTALLATION
WARNING: Failure to follow these instructions carefully could result in poor performance, property damage,
personal injury, or loss of life.
STEP 1. LOCATE VENT OPENING (Requires a 2-1/2” hole when not using vent weather seal kit).
a) Select area on wall where heater will be installed.
b) Check outside vent termination for proper clearances. See Figure 1.
c) Locate studs behind heater location.
d) Using template supplied, mark location for 2-1/2” hole between studs. See Figure 2.
e) Cut vent openings through both the inside and outside walls, being sure to maintain level
across both openings.
FLOOR
FIGURE 2
RIGHT END OF HEATER
VENT HOLE LOCATION FOR THE AIR
INTAKE AND EXHAUST TUBES FOR
STANDARD INSTALLATION 2-1/2” DIA.
HOLE. NOTE: 3” DIA. HOLE REQUIRED
FOR WEATHER SEAL KIT.
11-3/8”
7-3/4”
FLOOR