Coway P-06CR Water System User Manual


 
Safety Information
Operating Instructions Troubleshooting Tips Customer Service
01
02
11
12
HOW TO REPLACE FILTER
Step1
Step2
Step3
Step4
Filter replacement time is indicated
when the corresponding LED of filter
flickers in window display.
Close water lead-in valve and pull
out plug.
Unfasten screws. Then, hold both
side covers at the bottom and
force them upwards as if
pushing up to remove them
from the main body.
Each of A, B and C respectively
represents neo-sense filter,
RO membrane filter and fine post-
carbon filter.
Step5
Step6
Step7
Step8
Remove fitting from filter as shown in
diagram. Replace filters as required.
Take caution for safety at all times.
Insert both side covers and fasten
screws.
Check for normal operation of filter
replacement parts in window display.
Initialize filter setting by pressing the
corresponding button(for 3 sec) of
filter among the filter reset buttons
located at the back of the front panel.
Caution : When LED to indicate filter replacement is turned on, users must not attempt at
replacing filters on their own. Make sure to inquire after-sale service center.