A SERVICE OF

logo

Open as PDF
next previous
24
Installation the Remote Control Mount
5. Insert the rotating axis in the opposite side after
pulling out it from the remote control mount.
Inserttheaxiswiththethickerpartfacingthe
backoftheremotecontrolmount.
6. Insert the cover-axis in the hole on the opposite side
of the rotating axis.
Aligntwoprojectionswiththetwogroovesontheaxiswhen
insertingthecover-axis.
7. Fix the rotation axis and the cover-axis with a screw.
Pleasetightenthecover-axisrmly.Ifthescrewisloosely
assembled,theremotecontrolmountmaybeseparatedandis
dropped,whichmaycauseproductdamageorabodilyinjury.
8. Please separate the rubber stopper from the opposite
side of the bidet installed the remote control mount
before.
Pleasebesuretoinserttheseparatedrubberstoppertothe
oppositeremotecontrolmountxinggroove.Otherwise,the
productmaybreak.
9. Insert the rotation axis of the remote control mount
and x the remote control mount with the xing
screw (Ø 6) on the bidet bottom.
Pleasetightenthexingscrew(Ø6)rmly.Ifthescrewisloosely
assembled,theremotecontrolmountmaybeseparatedandis
dropped,whichmaycauseproductdamageorabodilyinjury.
INSTALLATION
1021214 BA08-A 사용설명서_미주향_(09.06.10)_003.indd 24 2009.6.10 6:17:2 PM