Filter
Top Products
1110
LIMITED LIFETIME WARRANTY
Each CX1000 Complete Air Purification System comes with a limited life-
time warranty. This warranty provides for repair or replacement of any
defective parts or components for two years from the date of purchase at
no charge for labor or materials. This warranty does not cover the
expendable UV lamp, which must
be replaced on an annual basis (1-year),
or the expendable filter cartridge media, which must
be replaced every
two years or sooner, depending on environmental conditions. All warranty
repair work must be performed either at the factory or by a factory certi-
fied service center. Shipping cost to the factory or service center is the
responsibility of the owner of the CX1000. To return product for warranty
repair, the customer must first contact the factory for a Return Materials
Authorization (RMA) number and a ship to address, as it may differ from
the manufacturing location. For material repaired under warranty, ship-
ping costs to the customer will be prepaid for the first two years only.
This warranty is provided to the original purchaser of the CX1000, and
may not be transferred, sold or bartered. This product is not warranted
against freight damage, failure resulting from misuse, connection to incor-
rect voltage, or acts of God such as fires, earthquakes, or floods.
REPLACING THE FILTERS
When the Yellow SERVICE SOON FILTER
indicator lights, the filters should be
replaced within 30 days.
1. Unplug the CX1000 power cord
from the electrical outlet.
2. Rest the CX1000 on its back (figure
8) to access the bottom of the unit.
3. Press-in locking clips at each end of
the front grill.
4. Lift bottom of grill and slide out
the grill from the top of the unit
(figure 9).
5. Pull out the two filters individually
and discard them.
6. Install new HEPA filter in lower slot
with its white layer facing upwards.
7. Install new pre-filter in the remaining slot with its green side facing
upwards.
8. Replace grill. Slide upper end into grill slot and snap the bottom
into place so that it locks.
9. Reset the filter replacement timer by lightly pressing the FILTER
RESET button on the Service Panel
with a pin or similar object. The
FILTER light will become green, and
time will be reset to zero.
Restore the CX1000 to normal operation
as follows:
1. Set the unit in its normal operating
position.
2. Plug the power cord into the wall
outlet.
figure 8
figure 9
figure 10