Filter
Top Products
104464-01E
For more information, visit www.desatech.com
For more information, visit www.desatech.com
8
INSTALLATION
Continued
Figure 6 - Laying Down Stove On Side (Stove Style May Vary Depending on Model)
Front of
Stove Unit
Pallet Wood
Bolted to
Stove Body
Bottom
Top of Stove Unit
Front of
Stove Unit
Top of
Stove Unit
Drop Cloth/
Blanket
STOVE CAVITY ASSEMBLY
1. Lift off corrugated box enclosing stove body crating.
2. Remove all screws fastening the wood frame enclosure.
Spread wood frame open and lift away from plastic-bagged
stove body. The bottom pieces of pallet wood will remain
bolted to the stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see Figure 5). Use an adjust-
able wrench or a 10 mm socket. Remove six (6) bolts and wash-
ers. Keep bolts and washers to reattach back panel later.
5. Remove all contents from inside stove cavity. Contents include:
(1) - Stove bottom
(4) - Legs (Amity models include leg leveler bolts)
(1) - Bottom door
(1) - Top grate
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to attach bottom components
to stove body (see Figure 6). Rest stove on drop cloth or blan-
ket to avoid scratching stove edges.
Figure 7 - Removing Pallet Wood From The Bottom of The Stove
Figure 8 - Locating Threaded Holes for Stove Bottom, Legs, and
Door Attachment (Appearance May Vary Depending on Model)
Figure 5 - Removing Back Panel
Bolt
Product
Identification
Label
Back Stove
Panel
Pallet
Wood
Bolt
Bottom Of
Stove Unit
Front
7. Remove remaining pallet wood attached to bottom of stove
body (see Figure 7). Use an adjustable wrench to remove bolts.
8. Fasten each leg to stove with four (4) bolts. Use a flat screw
driver to tighten bolt to leg. Thread bolt in tapped holes on
stove body (see Figure 8 and Figure 9, page 9).
Leg Hole
Leg Hole
Leg Hole
Leg Hole
Door Hinge
Step Bolt Hole
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Stove
Bottom
Holes
Front
Bottom Of
Stove Unit
Pallet Wood
INSTALLATION
Stove Cavity Assembly