Desa Tech ELCG347 Indoor Fireplace User Manual


  Open as PDF
of 16
 
10
2
3
1
The infrared remote control relies on a line of sight and must be pointed at the controls of the log set
to work. The remote control unit has the controls required to turn ON/OFF both the main power and
the heater. If you prefer to use the control buttons on the log set unit itself, they are on the lower right
corner of the unit. The layout of the buttons and remote control unit can be seen in Figures 3 and 5,
respectively.
1. Plug your log set into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the wall behind
the log set.
3. Remove plastic tab from inside battery compartment
to activate remote control.
4. Point the remote control directly at the control buttons of
the log set and use the buttons to operate the
log set.
Main Power Button:
This button supplies power to all the functions of the
log set. The main power button must be in the ON
position, either from the remote or the controls on
the log set for the functions to work.
Heater Control Button:
This button controls the heater ON/OFF and 5
temperaturemodesfromLowtoHigh.When
theheaterisrstturnedon,theheaterwillcomeonat
the lowest room temperature setting. The log set will
remember the last heat setting and in later use the heater
will start at that setting, unless power to the unit has been
interrupted. Each time the Temperature button is pressed,
the temperature set point increases, allowing you to adjust
the ambient temperature.
Flame Control button:
Thisbuttoncontrolsthebrightnessoftheameeffectwith
settingsatHigh,MediumandLow.Whenthelogsetisrst
turnedon,theamewillcomeonatthehighestsetting.The
logsetwillrememberthelastamesettingusedandinlater
usetheamebrightnesswillstartatthatsetting,unless
power to the unit has been interrupted. Each time the Flame
buttonispressed,theamebrightnessdecreases.Theonly
waytoturnofftheameeffectcompletelyistoturnoffthe
Main Power button.
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
Figure 4
OPERATING INSTRUCTION
1
2
3
Figure 5
(Pull tab)
 previous next