Filter
Top Products
22
104605
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
CHDV37N/P AND CHDV41N/P
REMOVING/REPLACING
GLASS DOOR
CAUTION: Do not operate this
fireplace with a broken glass door
panel or without the glass door
panel securely in place. For re-
placement part information see
Replacement Parts
, page 32.
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 45).
2. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 46).
4. To replace glass door, follow the above
instructions in reverse.
Figure 46 - Removing/Replacing Glass Door
Figure 45 - Removing Top Louver Panel
Glass Door
Assembly
Screw
Lower Bracket for
Glass Door Assembly
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
FIREPLACE
INSTALLATION
Continued
Attaching Magnetic Decorative
Brass Strips
This fireplace comes with a set of two mag-
netic decorative brass strips. Before attach-
ing strips to fireplace, remove plastic film
from brass pieces. After installing door,
attach these strips to the top and bottom of
glass door frame.
Top Louver
Panel