Filter
Top Products
3 Required
Large Screw
View from inside
looking upward.
4
Assembly cont.
■ Place collar ring in position as
shown.
Step 3
■ Load fire pan assembly.
■ Install 3 Phillips Head screws
through support ring in location
shown. Tighten screws.
Step 1 (cont)
■ Install two cover pieces to base.
5 Required
■ Unit is now ready for final
assembly.
Large Screw
■ Install log center piece.
■ Logs are marked A, B, C, D, E, which match markings on log support
ring.
■ Install log support ring so that
“A” is to the front of the unit
(Control Panel side).
Step 4
A
B
C
D
E
■ Notches in Support Ring must
match Electrodes on Burner.
Notches
Electrodes
Burner
NOTE: Make sure no wires are
pinched between fire pan and
support ring.
Fire Pan
Support
Ring
Step 2
■ Install top support ring between
cover and support brackets.
3 Required
Large Screw