Filter
Top Products
Page 8 Clarke
®
Model SPS-28 Space Sweeper Operator's Manual
HOW TO OPERATE THE MACHINE
NOTE: Do not attempt to operate the CLARKE Model
SPS-28 before reading the instructions in this manual.
WARNING: To prevent injury , always wear protec-
tive clothing. Do not wear loose cloth-
ing.
WARNING: Do not check the engine oil level when
the engine is running. Failure to check
the oil level before you use the machine
can destroy the engine. Always make
sure the machine has the correct amount
of oil.
Follow the procedures below when operating the machine:
1. Turn the timer-switch to the "OFF" position.
2. Insert the DC charger plug into the unkeyed battery bank
plug.
3. Plug the AC cord into a single phase grounded outlet with
voltage and frequency corresponding to the charger name-
plate. Assure that the circuit has adequate capacity to
handle the nameplate current.
4. Turn the timer-switch clockwise directly to the "ON" posi-
tion. The AC pilot light and the DC ammeter show that the
charger is on and charging.ammeter show that the charger
is on and charging. The charger will run for a total period of
sixteen (16) hours; the timer-switch knob will rotate
clockwise and automatically turn the charger off when the
pointer reaches the "OFF" position.
5. The charger may remain connected to the batteries for
extended periods without harming the charger or discharg-
ing the batteries.
How to Operate the Sweeper
1. Adjust the main broom to correct sweeping* by rotating
broom adjusting lever - clockwise to raise, counterclock-
wise to lower. (See Fig. 2)
2. Lower the main broom to "SWEEP" setting by placing the
adjusting lever in the horizontal latched position.
Fig. 2