Filter
Top Products
Clarke
®
Model SPS-28 Space Sweeper Operator's Manual Page 7
How to Prepare The Machine for Operation
1. Before starting the SPS-28B lift the battery box cover and
make sure the battery cables are connected.
2. Place all controls in "NEUTRAL".
3. Turn OFF/ON switch to "ON" position. (Switch is located on
left side, below hourmeter.
NOTE: The OFF/ON switch is also a circuit breaker which
senses overload on the drive motor and breaks the circuit.
Should this occur, determine the cause of the overload
(e.g., remove the debris jamming the main broom) and
turn the circuit breaker back to the "ON" position.
Model SPS-28B - Battery Powered
HOW TO CHARGE THE BATTERIES
Put the charger on a flat surface. Make sure the vents on
the sides of the charger are at least two inches away from
the walls and other objects. Make sure there are no
objects near the bottom vents of the charger.
To charge the batteries, follow this procedure:
1. Turn the machine OFF.
2. Connect the DC connector on the charger to the
connecting plug on the batteries. See Fig. 1
3. Connect the AC plug on the charger to a receptacle
that has the correct voltage and frequency for your
charger. Make sure the receptacle is connected to
the electrical ground.
4. The electronic timer stops the charger when the
batteries are fully charged.
See the instruction book for the charger, and for more
instructions on how to use the charger and charge the
batteries.
Fig. 1