Clarke SPS-28 Vacuum Cleaner User Manual


 
Page 6 Clarke
®
Model SPS-28 Space Sweeper Operator's Manual
How to Prepare The Machine for Operation
Model 28G (Gasoline Powered)
NOTE: Do not attempt to operate the CLARKE Model
SPS-28 before reading the instructions in this manual.
WARNING: To prevent injury , always wear protec-
tive clothing. Do not wear loose cloth-
ing.
Before starting the MODEL SPS -28G follow these instructions:
HOW TO CHECK THE OIL
WARNING: Do not check the engine oil level when
the engine is running. Failure to check
the oil level before you use the machine
can destroy the engine. Always make
sure the machine has the correct amount
of oil.
Follow this procedure to check the oil:
1. Make sure the machine is on level ground.
2. Turn the cap marked "Engine Oil" counterclockwise.
3. Lift the dipstick out of the tube.
4. If the mark is below "OK", add oil.
5. When adding oil, make sure the oil does not pass the mark
"FULL" on the dipstick.
See the engine manual for the correct type of oil.
HOW TO FILL THE GASOLINE TANK
WARNING: Fill the gasoline tank in an open area.
Do not fill the tank near open flames.
Do not fill the gasoline tank while the
engine is running. Gasoline is very flam-
mable and creates vapors. Serious injury
to the operator or others could occur.
WARNING: Gasoline is very flammable. When filling
the gasoline tank, make sure the gaso-
line only reaches the bottom of the filter
neck of the fuel tank.. Make sure you do
not spill any gasoline. Use a cloth to
remove spilled gas.
WARNING: Do not mix oil with the gasoline. Damage
to the engine could occur.
Fill the gasoline tank only with regular unleaded gasoline. Use
a clean container. Prevent dirt and debris from falling into the
tank. Always tighten the cap on the tank.