Filter
Top Products
CLARKE TECHNOLOGY Operator's Manual - Encore L26 Cylindrical Page -15-
4. Disconnect the battery pack connector from the control
housing connector. See figure 14A.
5. Connect the DC connector on the charger to the battery
pack connector. See figure 14B.
6. Connect the charger to a properly grounded single phase
(3-wire) wall receptacle having the input voltage, fre-
quency, and ampere capacity specified on the nameplate
of the charger.
For more information on the use of the charger, read
the instructions supplied with the charger.
How To Change or Rotate Brushes
To install or rotate brushes on the machine, follow this procedure:
1. Turn the key switch "ON".
2. Raise the brush head by pressing and holding the brush
switch until brush head is in full up position,
3. Turn the key switch "OFF" and remove the key.
4. Go to the front of the machine and remove thumb screw from
brush door (figure 15).
5. Lower door approximately ½ inch and slide door and bearing
assembly off shaft (figure 16).
6. Remove brush spacer and brush by sliding off of brush shaft
(figure 17).
7. Rotate brush or replace.
8. Slide brush on shaft and rotate slowly until drive pins are
lined up with brush slots. Push brush all the way in.
9. Install brush spacer on shaft.
10. Slide brush door bearing assembly on shaft.
11. Raise door and install thumb screw.
DANGER: Operating a machine that is not completely
or fully assembled could result in injury or
property damage. Do not operate this
machine unless it is completely assembled.
Inspect the machine carefully before
operation.
How To Prepare the Machine For Operation
Figure 14A
Figure 14B
Figure 15
Figure 16
Figure 17