Filter
Top Products
KSG110 Installation Instructions
8
2. Using Phillips screwdriver, slightly loosen or tighten
the adjustment screw as necessary (See Figure 10).
Figure 10
3. Reinstall display. See Display Installation in this
document.
Display Adjustment
Lateral position on display:
1. Using your fingers, slightly loosen adjustment knob "A".
(See Figure 11)
2. Slide display to desired position.
3. Using your fingers, tighten adjustment knob "A". (See
Figure 11)
PITCH / YAW / ROLL Tension
1. Using your fingers, slightly loosen adjustment knob "B".
(See Figure 11)
2. Adjust display as desired.
3. Using your fingers, tighten adjustment knob "B".
Figure 11
Swing Arm Tension
1. Using 3/16" hex wrench (C), loosen or tighten adjustment
screw(s) as necessary (See Figure 12).
Figure 12
Adjustment Screw
2
A
B