Chicago Electric 95591-.75 HP Water Pump User Manual


 
SKU 95591/95592/95593 For technical questions, please call 1-800-444-3353 PAGE 5
This Pump is designed to move clean or dirty water only. Do not pump water
hotter than 95 degrees Fahrenheit.
Make sure the discharge pipe 7. (not included) is secured to a solid surface to
ensure the stability of the Pump.
Make sure to position the Pump on a at, level, solid surface.8.
9. Arrange a “drip loop” in the Power Cord connecting the Pump to a 115 volt,
GFCI electrical outlet. A drip loop is that part of the Power
Cord below the level of the outlet to prevent water from
traveling along the Power Cord and coming in contact with
the outlet. If the Power Plug or electrical outlet does get
wet, do not unplug the Power Cord. Disconnect the fuse or
circuit breaker that supplies power to the Pump. Then,
unplug the Power Cord and examine for presence of water
in the outlet. (See Drip Loop, right.)
If necessary,10. have a certied electrician install (within 10 feet of where the
Pump will be located) a 115 volt, GFCI electrical outlet that is dedicated only
to the Pump. Any outlet should be above the water line.
NEVER raise or lower the Pump by its electrical Power Cord.11.
In cold weather, when the Pump is not in use, protect the interior of the Pump 12.
from freezing by draining the water and pumping a permanent type automo-
bile anti-freeze containing a rust inhibitor through the system. A 50% mixture
with water is recommended. Be sure to ush the system with a neutralizing liquid
prior to re-use of the Pump.
If an extension cord is used (for temporary use only) connections must not 13.
come in contact with water or any wet surfaces.
Prior to use, and periodically thereafter, check to make sure all connections 14.
are tight and secure.
Industrial applications must follow OSHA requirements.15.
Performance of this product may vary depending on variations in local line 16.
voltage.
People with pacemakers should consult their physician(s) before use. Elec-17.
tromagnetic elds in close proximity to heart pacemaker could cause pace-
maker interference or pacemaker failure.
The warnings and cautions discussed in this manual cannot cover all pos-18.
sible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
OUTLET
DEVICE
CORD
Drip Loop