Filter
Top Products
SKU 90981 Page 5
To Vacuum Dry Materials:
1. Note: A dry bag (19) is necessary when vacuuming dry material. If the Bag is
wet when vacuuming dry material, the Bag will clog quickly and become difficult
to clean. If the Bag is wet, dry the Bag before performing dry vacuuming.
See
Figures A, B, and Assy. Diagram.
2. To remove the Motor Housing (3) in order to empty the Container (20), or clean
or replace the Bag (19), pull outward on the latches located on each side of the
Container.
See Assy. Diagram and Figure C.
3. When vacuuming, make sure the Bag (19) is in the proper position to avoid leaks
an/or damage to the Vacuum/Blower. Check to make sure the Bag completely
covers the Ball Basket (17) and that the Rubber Band (18) is as close to the
Worm Cover (13) as possible. Any leaks will allow the vacuumed material to be
blown out of the blower port and back into the surrounding environment.
See
Figures A, B, and assy. Diagram.
4. To use the vacuum, insert the Hose (21) into the Vacuum Port. If necessary, you
may place the Hose Attachment (22) over the end of the Hose.
See Figures A,
B, and Assy. Diagram.
5. To turn on the Vacuum/Blower, plug the Power Cord (4) into a 110V-120V, 3-
prong, electrical outlet. Then, turn the Switch (1) to its “ON” position.
See
Figures A, B, and Assy. Diagram.
Figure A
6. Note: When vacuuming very fine dust, or a large amount of dry material, it may
be necessary to empty the Container (20) and replace Bag (19) at more frequent
intervals. To do so, remove the Motor Housing (3) from the Container (20). Empty
all debris from the Container. Remove the Rubber Band (18) and Bag from the
Ball Basket (17). Clean the Bag. Then, replace the Bag, Rubber Band, and Motor
Housing.
See Figures A, B, and Assy. Diagram.
7. When finished vacuuming, make sure to turn the Switch (1) to its “OFF” position
and unplug the Power Cord (4) from the electrical outlet.
Switch (1)
Power
Cord (4)
Blower Port
Vacuum
Port
Motor Housing (3)
Ball (16)
Ball Basket (17)
REV 03/04