Filter
Top Products
Page 4
SKU 03914
For technical questions, please call 1-800-444-3353.
physician(s) before using this product; operation of electrical equipment in close proxim-
ity to a heart pacemaker could cause interference to or failure of the pacemaker.
Note: Performance of this tool may vary depending on variations in local line voltage. Exten-
sion cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
Sewing Safety Precautions
1. Keep hands away from the needle when you turn the power switch on, or while the ma-
chine is operating.
2. Do not place your fingers into the thread take-up cover while the machine is operating.
3. Never leave the machine running and unattended.
4. During operation, never place your head, hair, or hands in the proximity of the hand
wheel, V-belt, bobbin winder, or motor.
5. Do not operate the machine with any safety guards removed.
6. This machine shall only be operated by appropriately trained operators.
7. For your personal protection, we recommend you wear ANSI approved safety glasses
when using the machine.
8. If oil or grease comes in contact with your eyes or skin, immediately wash the affected
areas and consult a physician.
9. Tampering, modifying or altering any device (aside from the cord and plug by a licensed
electrician) on the machine is prohibited and will void manufacturer’s warranty.
10. Repair, adjustment, and specific maintenance shall only be performed by a qualified
service technician. Alteration or replacement of the 3 prong grounded electrical plug
provided with the machine must only be performed by a licensed electrician. This ma-
chine must be properly grounded.
11. This sewing machine is only to be used for the purpose intended.
Unpacking
When unpacking, check to make sure that the parts shown in the photo on the following
page are included. Note that the machine table shown is not included, and must be ordered
separately. If any parts are missing or broken, please call Harbor Freight Tools at the num-
ber on the cover of this manual as soon as possible.