Ocean Electronic Tabletop Heater Electric Heater User Manual


 
OWNER’S MANUAL
7
Caution: this appliance is for outdoor use only(outside any enclosure)
Always make sure there is fresh air ventilation.
Use only outdoors in a well-ventilated space, never use in a building,
garage or any other enclosed area.
Always maintain at least 18“clearance(top)and 24”clearance (side)
from combustible materials.
Always place heater on a hard and level surface.
Do not use if the wind velocity is greater than 10 miles per hour.
Unit will operate at reduced efficiency below 40°F 5℃ .
Keep sprinklers and other water sources away from burner and
controls.
Always use extreme caution when near heater. Alert both children and
adults to the hazards of high temperatures , especially to avoid burns
or clothing catching fire.
Young children and pets should be carefully supervised when they are
in the area of heater.
Do not place clothing or other flammable materials either on or near
heater.
Any guard or other protective device removed for servicing the heater
must be replaced prior to operating the heater.
Certain materials or items, when stored under heater, will be subjected
to radiant heat and could be seriously damaged.
Do not alter heater in any manner.
The pressure regulator and hose assembly supplied with the
appliance must be used and replacements must be those specified by
the manufacturer.
Inspect heater before each use. If a damaged part is detected, do not
operate until an original equipment replacement part has been
properly installed. Use of unauthorized parts will void warranty and
create an unsafe condition.
Do not attempt to use this appliance without a functional factory-
supplied gas regulator in place. If regulator becomes damaged, use
only a factory-supplied replacement.
Prior to operating heater, replace any guards or protective devices
removed for servicing.
During operation, do not touch burner assembly. The surface of
heater's emitter can reach temperatures approaching 1600°F.
After shutdown, do not touch burner assembly until heater has
cooled(approximately 45 minutes after use).
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
()
Read and become familiar with this entire manual, especially the
following precautions .
SAFETY FIRST