Filter
Top Products
OWNER’S MANUAL
10
Lighting
1. Turn Gas control knob to “Off” position.
2. Push in and rotate the Control Knob to“Pilot”position. Depress igniter
button.
3. Once burner is lit, hold Control Knob in for at least 30 seconds and
release.
4. If burner does not stay lit, turn to“Off” position and wait 5 minutes and
repeat 2 and 3.
5. Once burner is lit, rotate Knob to desired heating level (LO: low ; HI:
high).
If you experience any ignition problem, turn off the heater and gas supply,
and consult “Troubleshooting” on page 12.
Emitter screen will become bright red due to intense heat. The color is
more visible at night.
Burner will display tongues of blue flame. These flames should not be
yellow or produce thick black smoke, indicating an obstruction of airflow
through the burners.
If yellow flame is detected, turn off heater and gas supply and consult
“Troubleshooting”.
Note: For your safety, Control Knob cannot be turned “Pilot” without first
depressing Control Knob in “Off” position and then rotating to “Pilot”.
1. Turn Gas Control Knob to “Off”.
2. Wait 5 minutes to let gas dissipate before attempting to relight burner.
3. Repeat the “Lighting” Steps 2 and 3.
1. Rotate Gas Control Knob to “Off” position. Normally, burner will make a
slight popping sound when extinguished.
2. Remove Door Plate.
3. Unscrew gas line from regulator.
4.Close Door Plate. Note: After use, some discoloration of the emitter
screen is normal.
Caution
Re-lighting
Avoid inhaling fumes emitted from the heater's first use. Smoke and
odor from the burning of oils used in manufacturing will appear. Both
smoke and odor will dissipate after approximately 30 minutes. The
heater should NOT produce thick black smoke.
When heater is ON:
Note: The burner may be noisy when initially turned on. To eliminate
excessive noise from the burner, turn the Control Knob to the LOW
position. Then, turn the knob to the level of heat desired.