Chamberlain 916GA Home Security System User Manual


  Open as PDF
of 4
 
ASSEMBLE SAFETY SENSORS
Insert hex head bolt through safety sensor and slide safety sensor into
bracket. Secure with wing nut.
MOUNT SAFETY SENSORS
Mount safety sensor assembly to post using appropriate hardware (not
provided). Safety sensors must be installed no higher than 24" (61 cm)
above the ground.
NOTE: Install safety sensor assembly with the two holes in the bracket
facing up and the LEDs visible at the top.
Safety Sensor Post
Mark Safety
Sensor Post No
Higher than 24"
(61 cm)
Safety Sensor Post
Safety Sensor
Assembly
Safety Sensor Post
Conduit
Safety Sensor Wires
Low Voltage
Wires to
Control Box
Wire Nuts
3
WIRE SAFETY SENSORS
1. Separate wires.
2. Strip 7/16" (11 mm) of insulation from low voltage wires.
3. Combine all like-colored wires and twist together with wire nuts.
 previous