Filter
Top Products
30
10000836
Vermont Castings, Majestic Products RHE Natural Vent Insert
B3 RHEFA and RHEFP Trims
For use with RHEDV32
Trim Assembly
1. Remove the front glass (Refer to "Glass Frame
Removal" section).
2. Install support window trim channel, top and bottom
brass trim by using the shortest black screw. (Fig. 45
& 46)
3. Install bottom decorative plate by simply sliding it
under the unit floor. No fastening is required for this
installation. (Fig. 47) Be sure to remove protective
cover.
4. Install the bottom louvre assembly by fastening the
hinges with four (4) screws to the pre-punched holes
in the cabinet.
5. Re-install the front glass.
6. Install the top louvre by using the hooks to hang it in
place.
Trim Top
Glass Frame
Screws
Trim Bottom
FP1295
Fig. 45 Install support window trim channel and top and
bottom brass trim.
Louvre
NOTE: Position
brass trim top as
shown (small end up)
to prevent heat
discoloration.
Glass Frame
FP1291
Fig. 46 Position brass trim to with small end up.
Bottom
Decorative
Plate
FP1292
Fig. 47 Slide bottom decorative plate under unit floor.
1
2
3
4
6
5
RHEFA & RHEFP Trim Replacement Parts
FP1296
Vermont Castings, Majestic Products reserves the right to make
changes in design, materials, specifications, prices and discontinue
colors and products at any time, without notice.
IMPORTANT: Only trim panel assemblies approved
by Vermont Castings, Majestic Products can be
used on these products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information:
Model and serial number, part description with finish
and part number.
Key Description RHEFA RHEFP
1 Trim Window
Top/Bottom 52624-AB 52624-PB
2 Plate Decorative
Bottom 17597-AB 17597-PB
3 Top Louvre Assembly 57905 57905
4 Bottom Louvre
Assembly 57906 57906
5 Support Window
Trim Channel 57909 57909
6Hinge 52356 52356
7 Fasteners Package
(Not Shown) 57916 57916