Filter
Top Products
22
10000836
Vermont Castings, Majestic Products RHE Natural Vent Insert
Optional Accessories
Ceramic Refractory
Optional for RHE25 and RHE32
Model Description
RHE25CR Ceramic Firebox Liner
RHE32CR Ceramic Firebox Liner
RHE42CR Ceramic Firebox Liner
1. Remove front glass (Refer to Glass Frame Removal
section)
2. Remove logs from unit.
Logs may be hot!
3. Remove refractory from packaging.
Refractory are fragile and must be
handled with care. Where at all possible,
two hands should be used when
handling.
4. Take center refractory and tilt so bottom edge slides
into support angle in back of fireplace.
5. Now press center refractory to back side of fireplace
and hold in place.
6. Take left or right refractory and align it so leading
edge faces outward. Place refractory in fireplace
side and slide it back to support center refractory.
7. Install metallic piece in the leading edge (RHE32
only).
8. Repeat Step 6 and 7 for remaining side refractory.
When side refractory is installed correctly,
the center refractory will be supported by
the side refractory.
9. Fasten top tab supports against refractory to hold
sides in place.
the Zero Clearance Kit and the requirements of the Air
Kit when planning out the installation.
Follow the instructions supplied with the Zero Clear-
ance Kit carefully for proper installation.
Remote Controls
Optional remote control units are available to control
different functions of the appliance.
Model Function(s) Controlled
MRC1 ON/OFF
MRC2 ON/OFF and Temperature
MRC3 ON/OFF and Temperature control
with a digital and a programmable
24 hour clock
IMT Wall mounted thermostat control
Left Side
Center
Right Side
Leading
Edge
Bottom Edge
FP1278
Fig. 26 Ceramic refractory.
Leading
Edge
A Trim Options for RHE25
A1 RHE25SSP, RHE25LP
Trim Assembly
RHE25SSP
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Slide on the trim top channel and fasten it from the
back side.
3. Install the trim top deflector using two screws.
4. Remove ALL plastic protective covering from brass
trim.
Trim Top
Deflector
Trim Frame Top Section
Side View
FP1261a
Fig. 27 Trim top deflector.
Zero Clearance Kit
For installations other than in existing woodburning
fireplaces such as new construction or renovation
projects, a Zero Clearance Kit must be used. The
HEZC enables these inserts to be installed in combusti-
ble environments. It is recommended that an Air Kit
(AKZC) be installed whenever using a Zero Clearance
Kit. Consideration must be given to the dimensions of
HE25LP
1. To install the kit you do not have to remove any
piece of brass, you just add the external pieces.
2. Remove the frame trim from the unit if it is already
installed.
3. Install trim channels (left and right sides) by remov-
ing the two screws that hold the side brass trim and
put them back to hold both parts.
4. Slide on the trim top channel and fasten it from the
back side.