Filter
Top Products
26
Vermont Castings Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
20003457
Thermostat
Wire / Gauge Maximum Run
18 40 feet
20 25 feet
22 16 feet
Thermostat Connection
(Optional) R Models Only
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge
thermostat wire to use for the length of lead required in
your installation.
1. Install the wall thermostat in the desired location
and run the wires to the stove location. Terminate
these leads with 1/4” female connectors.
2. Connect the thermostat wires to the valve. (Fig. 48)
This completes assembly of the PDV20 and SDVR
stove.
Install the Front and Top Plates
The Stardance stove shell is available with either a
solid front plate or an operable door front plate.
The front plates are installed in the same manner.
1. Grasp the Front Plate and lift it into position, engag-
ing the two steel tabs at the upper corners behind
the adjacent bosses in the Side Plates. (Fig. 49)
Seat the Front against the Sides so that the tabs at
the bottom lip engage with the notches in the edge
of the stove base.
When properly installed, the bottom of the Front Plate
cannot be pulled away from the sides without also
lifting it up.
2. If you are installing optional Warming Shelves, do so
now, according to the instructions supplied with that kit.
3. Install the Top Plate. The upper edges of the side
plates should seat into the channel on the underside
of the Top. (Fig. 50)
Switch
Assembly
Screws
Existing
Holes
ST315
Fig. 47 Attach switch assembly to rear shroud.
PILOT
ADJ
TP
TH
TPTH
ST228
Fig. 48 Attach switch wires to valve.
Fig. 50 Install top plate.
ST475a
Fig. 49 Install Stove Front.
ST407
Bottom Tabs
Engage Notch in Base