Filter
Top Products
8
WinterWarm Small Insert
2000888
3. Install the Chimney Connector Starter Pipe. (Not
supplied)
• Mark and drill two 5/16”, (8mm) holes 1⁵⁄₈”
(41mm) from the lower edge of the pipe. Locate
the holes on an axis that will be perpendicular to
the fireplace opening when the pipe is installed.
(Fig. 6)
• Install the threaded rod (A), into the starter pipe
using washers and hex nuts (B,C),on the outside
of the pipe. Tighten the nuts, but do not distort the
pipe opening. (Fig. 6)
• Secure the starter pipe to the chimney connector.
(Fig. 7)
4. Install the Floor Protector. Make sure the floor pro
-
tector satisfies the requirements discussed on Page
6.
5. Install the Optional Outside Air Adapter.
Follow
the instructions provided with the kit.
6. Install the Optional Surround Kit.
Follow the in-
structions provided with the kit.
7. Slide the Firebox into Position. At least two people
will be needed to move the firebox. Position the
firebox so the flue collar lines up with the connector.
Use the leveling screws at the front of the Insert to
adjust the level. Route the power cord to the side
nearest the power supply and test the fans.
1"
(35mm)
FP1097
WWsi
starter pipe
4/3/01 djt
FP1097
Fireplace
Front
Fig. 8 Install the threaded rod inside the Starter Pipe (not a
supplied item, starter pipe is available from the Chimney Con-
nector manufacturer).
8. Join the Chimney Connector to the Flue Collar.
• Assemble the draw-down hook and bar (D,E,F).
• From inside the firebox, reach up through the flue
collar and engage the hook over the threaded
rod inside the starter pipe. Position the steel bar
behind the two tabs within the flue collar and then
turn the wing nut clockwise to draw the starter
pipe down. (Fig. 7)
9. Connect the Blower power cord to the power
supply.
This completes installation of your WinterWarm Small
Insert.
FP1098
pipes to cabinet
4/01
Seat the Starter
Pipe on the two
tabs inside the flue
collar
Starter Pipe
Draw-down
Bar Assem-
bly
FP1098
Fig. 7 Attach starter pipe to flue collar.