Vermont Casting 2080 Indoor Fireplace User Manual


 
2
WinterWarm Small Insert
2000888
Introduction
Save These Instructions for Future Reference
The WinterWarm Small Insert is designed,
tested and listed for burning wood. Do not
burn other fuels.
The WinterWarm Small Insert is not listed for
mobile home installations.
Failure to follow these instructions may
result in property damage, bodily injury or
even death.
WARNING
This fireplace has not been tested with an
unvented gas log set. To reduce the risk of
fire or injury, do not install an unvented gas
log set into this fireplace.
Specifications ......................................................... 3
Installation .............................................................. 4
Operation ................................................................ 9
Maintenance ......................................................... 14
Catalytic Combustor Appendix .............................
20
Replacement Parts ............................................... 21
Table of Contents
Proposition 65 Warning: Fuels used in gas, wood-
burning or oil fired appliances, and the products of
combustion of such fuels, contain chemicals known
to the State of California to cause cancer, birth de-
fects and other reproductive harm.
California Health & Safety Code Sec. 25249.6
Thank you for purchasing a Vermont Castings WinterWarm Small Insert, an efficient fireplace carefully engineered
to bring you the latest in wood combustion principles and modern foundry technology.
While it can be used to transform a traditional masonry fireplace into a powerful heater, it is also designed to be
installed into a listed factory-built fireplace where no masonry fireplace and chimney exists.
Whichever installation you have chosen, you can count on years of comfortable heating and pleasurable fire-view-
ing if you operate and maintain it according to the directions in this Owner’s Guide.
The WinterWarm Small Insert has been tested and listed by Inchcape Testing Services / Warnock Hersey Inc. of
Middleton, Wisconsin according to ANSI/UL 1482 for the United States and ULC S628 for Canada. The WinterWarm
Small Insert is listed to, and in compliance with, the standards set forth by the Federal Environmental Protection
Agency, 40 CFR Part 60.532(b), as stated on the permanent label attached to each appliance.
This manual describes the installation and operation of the WinterWarm Small Insert catalytic-equipped wood
heater. This heater meets the U.S. Environmental Protection Agency’s emission limits for wood heaters sold after
July 1, 1990. Under specific test conditions this heater has been shown to deliver heat at a rate ranging from 8,700 to
31,000 Btu/Hr.
For more complete details on WinterWarm Small Insert performance and specifications, please refer to Page 3.
The WinterWarm Small Insert is designed, tested and listed for burning wood. Do not burn other fuels.
We recommend that you hire a professional installer to install your WinterWarm Small Insert, or to advise you on
the installation should you attempt to install it yourself.
Please read the sections of this manual which apply to your installation before you install and use your Winter-
Warm Small Insert.
Failure to follow these instructions may result in property damage, bodily injury or even death.