Vermont Casting 1990CE Stove User Manual


 
12
Intrepid II Woodburning Stove
30003840
ST515
reverse
flue collar
11/17/00 djt
Flue Collar Screws
ST515
Fig. 16 Reversing the flue collar.
Attach the Griddle Handle
Install the handle on the griddle. Place the griddle
upside down at the edge of a flat surface and assemble
the handle as shown. (Fig. 17)
With the handle pointing 45° from its final position,
tighten the nut as far as possible with pliers. Move the
handle to its final position while still holding the nut with
the pliers. Take care not to overtighten, as tab may
snap.
ST516
Attach
griddle handle
11/17/00 djt
ST516
Fig. 17 Attaching the griddle handle.
Operation
Your Intrepid II’s Controls and
What They Do
The stove has two controls to regulate performance: a
primary air control supplies oxygen for the fire, and a
damper directs air flow within the stove to activate and
deactivate the catalytic combustor.
Additional air for catalytic combustion is regulated auto-
matically, and does not require operator control.
Symbols cast into the stove are reminders of the correct
directions for opening and closing the controls. In these
directions, ‘left’ and ‘right’ assume that you are facing
the front of the stove.
A Single Air Control Regulates the
Amount of Heat the Fire Will Produce and
How Long it Will Burn
The primary air control lever, located at the right rear
corner of the stove, controls the amount of incoming air
for starting, maintaining, and reviving a fire. More air
entering the stove makes the fire burn hotter and faster,
while less air prolongs the burn at a lower heat level.
For the greatest air supply and maximum heat output
(but the shortest burn time), move the lever to the left.
For a fire that will last longer with less heat, move the
lever to the right. You can set the lever anywhere in
between the left and right extremes. (Fig. 19)
The Intrepid II features an automatic thermostat to en-
sure an even heat output at any setting you select. The
thermostat senses the heating and cooling of the stove
surface and adjusts the air shutter accordingly.
ST518
Intrepid II
controls
11/20/00 djt
Air Control Lever
Griddle
Handle
Damper Handle
Door Handle
Door Handle
Holder
(Behind Leg)
Ash Pan
Andiron
ST518
Fig. 18 The Intrepid II controls.
ST517
Intrepid II
Thermostat
positions
11/17/00 djt
High Heat
Low Heat
ST517
Fig. 19 The thermostat handle may be positioned anywhere
between the two extremes for different heat levels.
Rear View