Filter
Top Products
Instructions for installation
ELECTRICAL CONNECTION
The appliances are provided with a three-pole feeding cable and work with
alternate current and single-phase voltage indicated on the “rating plate of
the product “report at the end of the instruction manual and on the product.
The grounding conductor of the cable is marked with the colours
yellow/green.
CONNECTION OF THE FEEDING CABLE TO THE MAINS
Connect the feeding cable to a plug suitable for the load indicated on the
rating plate of the product. In case of a direct connection to the mains
(cable without plug), it is necessary to insert a suitable omnipolar switch
before the appliance, with minimum opening between contacts of 3 mm
(the grounding wire should not be interrupted by the switch).
Before connecting to the mains, make sure that:
• the electrical counter, the safety valve, the feeding line and the socket are
adequate to withstand the maximum load required (see rating plate).
• the supply system is regularly grounded, according to the regulations in
force.
• the socket or the omnipolar switch can easily be rea-
ched after the installation
• after carrying out the connection to the mains, check
that the supplying cable does not come into contact
with parts subject to heating.
• never use reductions, shunts, adaptors which can
cause overheating or burning.
When the appliance is to be installed above a built-in oven, the two applian-
ces must be connected separately, to make it easier to take the appliances
out and for electrical safety.
The manufacturer is not liable for any direct or indirect damage cau-
sed by faulty installation or connection. It is therefore necessary that
all installation and connection operations are carried out by qualified
personnel complying with the local and general regulations in force.
002 LINGUE 28-09-2005 19:29 Pagina 31
IE
GB
28