Filter
Top Products
4
Step 2. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2
1
/4″ long
canopy screws and canopy lock washers. Hand
tighten until snug against the ceiling.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ‘Approved For Ceil-
ing Fan Installation’ ceiling fixture outlet box with the outlet
box mounting hardware.
Tighten the screws firmly, being careful not to bend the
bracket by over tightening.
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
GREEN
GROUND
WIRE
CEILING FAN
APPROVED
WIRING BOX
RIDGE
SIDE
DOWN
CANOPY INSTALLATION
CANOPY LOCK
WASHERS
CANOPY
SCREWS
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
CANOPY HARDWARE
CANOPY
CANOPY
HATCH
CANOPY LOCK WASHER (4)
CANOPY SCREW (4)
APPROVED
OUTLET BOX
HARDWARE
Note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
METROPOLITAN
™