Filter
Top Products
www.CasablancaFanCo.com
1.888.227.2178
Switch Housing & Light Kit (continued)
If installing the LED light:
Attach the LED assembly to the
switch housing by installing
two light kit assembly screws,
found in the hardware bag,
through the slots, not the screw
holes.
If installing the No-Light Cap:
Skip this step.
Position the notches in the outer rim
of the globe or no-light cap so they
line up with the tabs on the inside
rim of the upper switch housing.
Carefully lift the globe or no-light
cap up as far as it will go, then rotate
clockwise until it is held tightly in
place by the tabs.
Attach the switch housing cap
to the lower switch housing by
installing two light kit assembly
screws, found in the hardware
bag.
Notch
Tab
16
M8527-01 • 04/16/15 • © 2015 Casablanca Fan Company