Filter
Top Products
Unit Positioning — The unit can be mounted on the
floor for vertical application with return air entering the face
of the unit and supply air discharging vertically through the
top of the unit. The unit can also be applied in a horizontal
arrangement with return air entering horizontally and the sup-
ply air discharging horizontally. When applying the unit in
a horizontal arrangement, ensure the condensate drain pan is
located at the bottom center of the unit for adequate con-
densate disposal. See Fig. 3 for condensate connections for
each unit position.
Typical positioning and alternate return air locations are
shown in Fig. 3. Alternate return air locations can be used by
moving the unit panel from the alternate return air location
to the standard return air location.
IMPORTANT: Do NOT attempt to install unit with
return air entering top panel of unit. Condensate will
not drain from unit.
*YC and WD option codes for all 034 size units and 008, 010 units with 208/230-1-60
power designate standard motor and high-static drive.
NOTE: See the following table for the sizes available for each unit.
UNIT 007 008 010 012 014 016 024 028 034
40RM XX XXXXXX
40RMQ XXX
40RMS XXXXXXXX
Fig. 2 — Model Number Nomenclature
LEGEND
Accessory Line
Alternate Air Intake and Discharge
Air Intake and Discharge
Fig.3—Typical Unit Positioning
11