Filter
Top Products
Installation of Close Clearance Shields (Optional)
1. Taking close clearance side shields, hold up to side of stove leaving 1/4" gap between
shield and top of stove.
2. Make reference mark in center of pre-punched hole in top & bottom of shield. Drill two
(2) 3/32" holes in back of unit on each side. Insert self-tapping screws in through shield
into stove.
3. Drill two (2) 3/16" holes in the sides of the stove where the shield meets the front side.
Insert two (2) 3/8" self-tapping screws.
4. Next loosen two (2) top screws holding side shield at rear top. Insert pipe shield where
back shield and top rear side shield meets. Tighten screws.
22