Filter
Top Products
PREPARING LOG KIT
Open the cartons containing the Burner Base and the M-3019 logs. The logs are numbered
as follows: (1) Front, (2) Rear, (3) Right side top, (4) Left side top.
WAR N I N G : POSITIONING OF LOGS IS VERY CRITICAL (SEE FIGURE 7).
(1) POSITION REAR LOG (#2) , IN REAR LOG HOLDERS, CENTERING LEFT TO
RIGHT.
(2) PLACE FRONT LOG (#1) OVER FRONT PART OF BURNER TUBE. LOCATE LOG
IN THE CENTER OF THE BURNER BASE. MAKE SURE THE MIDDLE SUPPORT
LEG OF THE FRONT LOG IS IN THE HOLDERS LOCATED IN THE CENTER OF
THE BURNER BASE, JUST BEHIND THE FRONT PART OF THE BURNER TUBE.
(3) TAKE RIGHT TOP LOG (#3) AND PLACE IT IN THE SLOTS LOCATED AT THE
RIGHT SIDE OF THE FRONT AND REAR LOGS, FACING THE BURNER BASE.
(4) PLACE LEFT TOP LOG (#4) IN THE SLOTS OF THE LEFT FRONT AND REAR
LOGS.
(5) WHEN IGNITING THE BURNER, CHECK AND MAKE SURE THE FLAME IS NOT
TOUCHING EITHER SIDE OF LOG (#3), OR LOG (#4). IF FLAME IS TOUCHING
LOGS ON EITHER SIDE, MOVE SLIGHTLY TO THE LEFT OR RIGHT TO
ELIMINATE THE FLAME FROM TOUCHING EITHER LOG.
Figure 7
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only
parts specifically approved with this heater may result in property damage or personal injury.
TOP LEFT
TOP RIGHT
REAR LOG
FRONT LOG
Page 16