Filter
Top Products
IMPORTANT SAFEGUARDS
Although your gas logs are very realistic in appearance, it is not a real burning fireplace and must not be
used for burning rejected material.
• To avoid irreparable damage to the heater or personal injury, matches, paper, garbage, or any other
material must not be placed or thrown on top of the logs or into the flames.
• To avoid personal injury, do not touch hot surfaces when the heater is operating.
• Close supervision is necessary when the heater is being operated near children.
WARNING: THE LOGS ARE MANUFACTURED FROM
BONDED CERAMIC FIBER. THIS IS A COMMONLY USED
MATERIAL IN INDUSTRY WORLDWIDE. IN THE EVENT THAT A
LOG SHOULD BE REMOVED, CARE SHOULD BE TAKEN NOT TO
DAMAGE THE BONDED MATERIAL.
INTENTIONAL MISUSE OR DELIBERATELY FRAGMENTING THE
MATERIAL COULD LEAD TO INHALING FIBERS AND BE
HAZARDOUS TO YOUR HEALTH.
THIS HEATER IS INTENDED FOR USE AS A GAS HEATER
FIREPLACE AS DESCRIBED IN THESE INSTRUCTIONS. IT SHOULD
NOT BE USED FOR ANY OTHER PURPOSE.
CLEANING
CAUTION: BEFORE CLEANING OR MOVING THESE LOGS OR
OTHER PARTS OF THE HEATER, BE SURE TO READ THE ABOVE
SECTIONS ON “IMPORTANT SAFEGUARDS.”
The appliance must be turned “OFF” before cleaning inside the firebox (burn
area), make sure the pilot is “OFF” completely and the appliance has cooled.
• All cleaning should be carried out when the heater is cold. Limited cleaning is required
with normal use. Dusting the front of the base, the top of the piezo cover, or the control
knob panel may be required occasionally. Do not use cleaning fluids to clean the logs or
any other part of the heater.
• If the flames show unusual shapes or behavior, or if burner fails to ignite properly, the
burner holes may require cleaning. If this occurs, contact your nearest dealer to service the
heater.
• The heater can be cleaned by removing the logs. Lift the logs gently, as not to damage the
fiber pieces. The logs have been spot glued in place for shipping, use caution when
removing. Lift each log by holding it carefully at each end. Use a vacuum cleaner to
remove dust and loose particles from the base, logs and around the burner and ODS/Pilot.
Gloves are recommended to prevent fibers from breaking the skin. If skin is broken, clean
with soap and water.
WARNING: Failure to keep the primary air openings(s) of the burner(s) clean may result
in sooting and property damage.
Page 29