Filter
Top Products
6. Slide the unit out and install the trim panels with a drill or screw gun. (Self tapping screws
provided).
NOTE: Make sure the gas supply line is hooked up at this time, and check for leaks at the
connection using soap and water.
CAUTION: Do Not use an open flame to check for leaks.
7. Place logs on the burner base as shown on page 16.
8. For gas hookup and pressure tap test, see instructions on pages 17 & 18.
NOTE: When operated for the first time, the logs and paint may emit a “paper burning smell”.
This smell will gradually diminish after a few hours of operation. Run the heater with the flue
damper, windows or doors, open during this time. DO NOT use blower at this time.
Page 7