Bryant T6--NHP Thermostat User Manual


 
3
INTRODUCTION
Bryant’s 7--day, 5/2-- day, 1-- day programmable and non-- programmable
Preferredt Series Thermostat Control is a wall--mounted, low--voltage control
which combines temperature and humidity control in either a single unit or a
two--piece unit. In two--piece configuration, the relays are located near the
equipment and a two-- wire connection is used between the Display Module and
the Equipment Control Module. Single--piece installation requires more wiring
and results in a higher profile. The Preferred Series Thermostat has no need for
batteries to store user--configured settings in memory. During power loss its
internal memory saves settings for unlimited time, and the clock continues to run
for at least 24 hours. An extension of Bryant’s proven line of thermostats; it
provides separate setpoints for heating and cooling in a ddition to humidification
and dehumidification.
In the control’s programmable configuration, different heating and cooling
setpoints and times are programmable for 4 periods per day or 2 periods per day.
Programming can be done for 7 days per week, 5/2 days per week, or 1 day. The
programmable Thermostat Control can also be user configured as a
non-- programmable Thermostat Control. When operating as non--programmable,
the Preferred Series Thermostat Control will still have both t emperature and
humidity control.
The non-- programmable Thermostat Control features Touch ’N’ Got settings
for quick and easy temperature change without complicated programming
schedules. The non--programmable Preferred Series Thermostat Control will still
have both temperature and humidity control. And, its Touch ’N’ Go technology
enables the user to switch between three different user--configurable settings
through intuitive buttons located just below the display.