Filter
Top Products
S-7200A
4. INSTALLATION
12
4-3. Lubrication (-[]0[], []3[] specifications)
* If the sewing machine is –[]5[] specifications, it is a
complete dry type machine, and so no lubrication is
necessary.
CAUTION
Do not connect the power cord until lubrication has been completed, otherwise the machine may operate if the
treadle is depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get
into your eyes or onto your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and
diarrhea.
Keep the oil out of the reach of children.
The sewing machine should always be lubricated and the
oil supply replenished before it is used for the first time,
and also after long periods of non-use.
Use only the lubricating oil (Nisseki Mitsubishi Sewing
Lube 10N; VG10) specified by Brother.
* If this type of lubricating oil is difficult to obtain, the
recommended oil to use is <Exxon Mobil Essotex SM10;
VG10>.
1. Tilt back the machine head.
2. Remove the rubber cap (1), and pour 150 ml of lubricating
oil from the accessory oil bottle (2) into the oil tank (3).
(Use the reference line (4) as a guide when pouring.)
3. Replace the rubber cap (1).
4. Return the machine head to its original position.
5. Check that the oil gauge (6) comes to the upper reference
line in the oil gauge window (5).
* Be sure to add more oil if the oil gauge (6) is below the
lower reference line.
2104M
Upper reference
line
Lower reference
line
2105M