Filter
Top Products
Upper Threading 37
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d
Insert the extra spool pin into the end of the
bobbin winder shaft, and install the thread
spool on it. Then, thread the upper thread.
a Bobbin winder shaft
b Extra spool pin
c Thread spool
Memo
z When setting the thread spool, set it so that
the thread winds off from the front of the
spool.
e
e
Thread the upper thread for the right side in
the same way that the upper thread for the left
side was threaded.
• For details, refer to steps
g through j of
"Threading the upper thread" (page 32).
f
Without passing the thread through the needle
bar thread guide, manually thread the right
needle.
Pass the thread through the eye of the needle
from the front.
CAUTION
g
Attach zigzag foot "J".
For details on changing the presser foot, refer to
"Replacing the Presser Foot" (page 43).
CAUTION
h
Turn on the sewing machine and select a
stitch.
• For stitch selection see "Selecting stitching"
(page 51).
• See "Stitch Setting Chart" (page 72) for
stitches that use a twin needle.
CAUTION
● The needle threader cannot be used with
the twin needle. If the needle threader is
used with the twin needle, the sewing
machine may be damaged.
● When using the twin needle, be sure to
attach zigzag foot "J". If bunched stitches
occur, use presser foot "N" or use a
lightweight tear-away stabilizer.
● When using the twin needle, be sure to
select an appropriate stitch, otherwise the
needle may break or the machine may be
damaged.